Jump to content

"im mainly......"at it again


ditchman
 Share

Recommended Posts

On ‎01‎/‎05‎/‎2019 at 22:41, ditchman said:

aahhhh shucks you say the nicest of things....................

used a dremel cutting disc then chaned it for a diamond cylinder router...which i did by hand......had to practice first tho..

gifted tart nice work again hand made gets my attention 👍

Edited by Saltings
Link to comment
Share on other sites

  • Replies 256
  • Created
  • Last Reply

Top Posters In This Topic

tomorrow im going to heat treat farriers blade.............ive been putting it off as it is out of my comfort zone.......but i have to bite the bullet now............

 

be prepared for large ammounts of cussing..:mad:

Link to comment
Share on other sites

16 minutes ago, old'un said:

Just get it red hot and wave it about.

That’s about dull cherry red in my book 

the waving about bit only comes from hot slag dropping in your boot 

all together in the burnt foot dance 😂

 it’ll be fine have some confidence and a bit of backbone 

and a darkish room is a good tip 🤭 

Link to comment
Share on other sites

8 minutes ago, Old farrier said:

That’s about dull cherry red in my book 

the waving about bit only comes from hot slag dropping in your boot 

all together in the burnt foot dance 😂

 it’ll be fine have some confidence and a bit of backbone 

and a darkish room is a good tip 🤭 

He might have to dip it in a bucket of water if he drops it down his trousers. :)

Link to comment
Share on other sites

7 minutes ago, old'un said:

He might have to dip it in a bucket of water if he drops it down his trousers.

Oil !!!!!!! 

And the oil bath should lay north to south 

plunged in at the south end and moved to the north 

we don’t want to get a warped blade 

arr it’s a dark side ditchman is moving into 

welcome to the dark art 😉

Link to comment
Share on other sites

nun of you have been listening to a word ive said ...............ITS D2 YER WALLIES..........air cooled .................

nun of this dipping in stuff...................imon the shiaz to-nite,............give me luuuve.. babe:wub:

Link to comment
Share on other sites

1 hour ago, Old farrier said:

That’s about dull cherry red in my book 

the waving about bit only comes from hot slag dropping in your boot 

all together in the burnt foot dance 😂

 it’ll be fine have some confidence and a bit of backbone 

and a darkish room is a good tip 🤭 

Which of his hot slags is this?

Link to comment
Share on other sites

1 minute ago, Old farrier said:

The one with the big feet and stilettos 😂

That doesn't narrow it down much!

11 minutes ago, ditchman said:

nun of you have been listening to a word ive said ...............ITS D2 YER WALLIES..........air cooled .................

nun of this dipping in stuff...................imon the shiaz to-nite,............give me luuuve.. babe:wub:

Quote of the year so far!

Link to comment
Share on other sites

well i eventually got around to it............in order to bring it up to the right hardening temp' i turned the fan heater on and pointed it into the grate...which worked a treat  and was able to reach a nice orange colour with a hint of yellow..............then i cleaned it up and tempered it on a piece of stainless steel plate on the hot plate of the cooker and watched as it evenly reached the pale straw colour................

let it cool and started to clean it up with emery paper..........you can tell it is nice and hard by how it feels and sounds..............if the blade had been a clip point i would have used a higher temp on the temper so it would be a little softer........but as this blade has a good spine i went for the harder option..........

have included the last pic as a compari9sion twixt the colours

hardening &temper 001tn_.JPG

hardening &temper 002tn_.JPG

hardening &temper 003tn_.JPG

hardening &temper 004tn_.JPG

hardening &temper 005tn_.JPG

hardening &temper 006tn_.JPG

hardening &temper 007tn_.JPG

Edited by ditchman
Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

Loading...
 Share

  • Recently Browsing   0 members

    • No registered users viewing this page.

×
×
  • Create New...